I don't know what type of transducers are in other boats, but this is how my wired, no-drill one works. Mineral oil is used because it's thicker. That way it's not shooting through a pocket of air before it goes through the hull and the water. So, because the bottom of the tranducer isn't touching the hull itself, you fill the base piece with mineral oil. I used 3m 5200 fast cure to affix mine.Īctually, this is a great picture of the two pieces that I have. The flange is what is affixed to the inside of your hull. The mounting piece is open at the bottom. The mounting piece is really just a tube with a flange on the bottom and a mechanism for the transducer to snap into it at the top (with an o-ring to seal that connection). The transducer snaps into the top of the mounting piece. In this pic, the baseplate is the piece on the right, and the transducer is upside down on the left. So, on my depth gauge, there's a wired transducer that has a baseplate that is affixed to the hull. How do you fill the transducer ?Have not had a working depth gauge for years now also see the. Check out our boat inventory for new and used Ski, Wakeboard, Jet, Bow Rider & other luxury boats. The reason I went with the Faria/Airmar combo is simply because the previous owner of my boat bought it and never got around to installing it and included it with the boat purchase. this New 2022 Blackfin 272CC for sale in Gainesville, GA. It's not bad with the red backlighting, but it doesn't match anything else I have. I don't like the fact that the LED backlighting is integrated into the Faria gauge and can't be changed. That said, if I was to do it all over again, I'd probably get a thru-hull transducer (getting water temp would be a bonus, although I already get water temp with my Perfect Pass paddlewheel). That finally did the job and seems to be working great. I cleaned everything up and reapplied the transducer base with some 3m 5200 Fast cure. So I pulled the base off my hull and the silicone peeled right off. That lasted 1/2 a season and then I was having to top it off way too often. So I used JB weld on the inside and outside of the base in hopes of making it not leak out mineral oil anymore. Mine ended up leaking out some of the mineral oil. You fill the base with mineral oil and lock the transducer into it. I had some frustrations with mine because I first mounted the transducer with silicone to the hull. I have a faria with a airmar in hull transducer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |